Rear axle for early Ducati singles. Made from heat treated 4140 steel with integral center spacer. |
|
Crank cover for TD1C Yamaha. Part number 170-11511-00-00 |
Td2 gas cap latch part number 256-24628-00-00 Machined from 6061-T6 aluminum |
Clutch plates for a Brough Superior | |||
Cap for 35mm Ceriani forks |
|||
Case plugs for CanAm 400. Replaces the plastic originals and can be lock wired for racing. |
|||
Exhaust nut wrench for Ducati singles |
|||
|
Shrunk on sleeve to support and tighten wheel bearings on Ducati single |
I machined these top end needle cages so I can use RD250 pistons in my RD200. The 250 uses a larger wrist pin and the only needle bearings available in the right size had plastic cages. |
|
|